condor d.c. power supplies, inc., a subsidiary of sl industries, inc. 805-486-4565 ?(800) 235-5929 fax: (805) 487-8911 http://www.condorpower.com model output rating pwr out 1000 watts power factor corrected single output, hot swap the 1000-watt tcm series ?ot swap- pable?power supplies deliver remarkable economy and reliability in applications that require redundancy over extended temperature ranges. these high-density, single-output supplies are available with a front panel and handle for use in sub-system racks or without handles for embedded applications. power factor correction, or-ing diodes, and current sharing make the tcm series an ideal choice for communica- tions and data processing systems utilizing distributed power or redundant power architecture. standard tcm series TCM-1000 featuring: diode isolated output for hot swap ?ero wire?slope program current sharing high power density 6.5 watt/cu. in. industry standard din connector 0.99 typical power factor dc power good and ac power fail signals true remote inhibit monotonic turn-on and turn-off extended temperature operation high efficiency 87% typical (48 v units) operating temperature range -20? to +60? TCM-1000-24 24v @ 41.6a 1000 TCM-1000-28 28v @ 35.7a 1000 TCM-1000-48 48v @ 20.8a 1000 see trs (rack system)
specifications: all models input ac input: 180-264 vac, 47-63 hz internally fused 10 a. power factor: 0.99 typical at full load. meets en61000-3.2. inrush: limited by thermistor, 40 ampere maximum (8ms), cold start. hold up time: 20 ms minimum after removal of power supply at full load. efficiency: 87% typical @ full load. ac power fail: provides ttl "o" 5 ms before output voltage goes out of regulation band upon loss of ac power. output adjustability: user adjustable ?% minimum. output: 48 v @ 20.8 amp. (1000 w max.). line regulation: ?.2% load regulation: ?% (slope program) from 0 to 100% load changes. turn on delay: 1 second typical. ripple & noise: 0.5% p-p, measured at 20 mhz bandwidth. temperature coefficient: 0.02% per degree c. stability: 0.1% over 8 hours, under constant line, load and ambient. transient response: output voltage returns to within 1% in less than 500 ? for a 50% load change. peak transient does not exceed 3%. overload protection: electronic current limit, 120% maximum. overvoltage protection: protects load against power supply induced overvoltage. trip point is factory set so that output voltage cannot exceed 136% of nominal. requires ac input to be cycled to reset. remote inhibit: contact closure or ttl "0" turns off output. dc power good: provides a ttl "0" open collector when output is above 90% of nominal maximum pull-up voltage 30 vdc; maximum sink current, 10 ma. redundancy: built-in or-ing diode, slope program current sharing, and din blade connector provide "hot swap" and "n+1" capabilities. current sharing remains within 10% of the unit's full output rating given 0.2% initial accuracy in the output voltage setting. current sharing: as calibrated at factory, modules will share current within 10% of full rated load. reverse voltage: protected against reverse voltage up to twice output voltage rating. (internal or-ing diode.) 1000 watts 13.27? 4.87? 2.49 TCM-1000 function location notes connector output z12 d14 z16 d18 (+) polarity voltage z4 d6 z8 d10 (-) polarity function location notes connector dc power good z20 reference to ac power fail d22 common inhibit z24 location 230 vac connector z32 line 1 d30 line 2 z28 safety ground ac input (180-264 vac continuous range) dc output eurocard connector - male din 41 612 level 1- type h eurocard connector - male din 41 612 level 1- type h eurocard connector - male din 41 612 level 1- type h status and control TCM-1000 5.2 lbs - 2.6 kgs dimensions: inches millimeters environmental thermal protection: shuts down power supply if overheated. automatic recovery. temperature range: -20 to +60 c, full power, de-rate to 66% maximum power @ 71 c. safety agencies: approved to ul1950; csa 22.2 #950; iec 950 and tuv en60950, class 1 selv, ce 73/23/eec//93/68/eec (low voltage directive). conducted rfi: meets fcc part 15, subpart j, class a; en55022 class b; and cispr 22 class b. output isolation: isolated from ground 100 vdc. cooling: self-cooled by internal ball-bearing fan. options option "r" - rack mount panel: special panel that is required for rack mounting. consult factory for other available options. condor d.c. power supplies, inc., a subsidiary of sl industries, inc. 805-486-4565 ?(800) 235-5929 fax: (805) 487-8911 http://www.condorpower.com
|